Page 176 of 176 FirstFirst ... 76126166174175176
Results 1,751 to 1,752 of 1752

Thread: What did Chief do to his Mazdas today?

  1. #1751
    Now with pictures, but not for you! chiefmg's Avatar
    Join Date
    Dec 2007
    Location
    N KY
    Miata: Last time I autocrossed I used the larger front sway I have. When I swapped back to the MSM bar I found the larger one had been moving side to side, resulting in damage to the bushings. The larger bar does not have any stops to prevent this from happening. Solution was to source a couple of split collars to use as stops:





    I bought the first one from Amazon for $7.29. It was the last one so waited a day or two to see if the stock came back up, but it was going to be 2-3 months before they were back in stock. After some searching found the same one on a different site, this time it was $28. Overall cost was $35 which isn't bad for a set of precision stainless collars. I'll post pictures of them installed once I get the bushings I have ordered.

    More deliveries set for tomorrow, then the fun begins.

  2. #1752
    Now with pictures, but not for you! chiefmg's Avatar
    Join Date
    Dec 2007
    Location
    N KY
    Miata: Finally got around to checking for a parasitic electrical drain. To do this, you connect a multimeter between a battery terminal and the cable out (I did it using the negative terminal to keep from worrying about any shorting issues) and then put the meter on the max amp scale (in my case this was 10 amps). You need to make sure nothing is turned on when you do this as you want to measure anything that shouldn't be there. For additional info see the following video: https://www.youtube.com/watch?v=zdIKNnwEjIs It is very thorough and should be easy for anyone to follow (even without any electrical background).

    My result? A whopping 0 amp flow. Whatever I may have going on, there is nothing that is pulling down the battery in that manner. Might be looking at getting a replacement alternator after all.

    So today I received a couple of packages:





    Unfortunately I think the brake master cylinder I received is for an ABS equipped car so it isn't going to work for me. I ordered a new/rebuilt one from Rock Auto to correct that problem. Just for shits and grins I mounted up one of the front calipers and rotors to check wheel clearance. I am happy that it all looks good. No pictures until I get everything installed (patience is a virtue). Looks great though, the bigger Sport rotor really fills things up.
    '81 RX-7, '00 Miata SE, '06 RX-8 (wife's), '15 CX-5 GT AWD.

Page 176 of 176 FirstFirst ... 76126166174175176

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •